Lesson notesDomain 4: Installation and Establishment · 9% of the exam
Planting a tree to standard
When to plant, preparing the site and hole, setting the depth, removing packaging, correcting roots, backfilling, watering and mulching.
Key points
TimingWhen roots can grow and water is available (often fall and spring); bare root only when dormant.
Hole2–3 times the root ball width, no deeper than the ball, sitting on undisturbed soil.
DepthRoot flare at or slightly above grade; too deep is the most common mistake.
Roots and packagingRemove containers, twine and at least the top of burlap and wire; correct circling roots; shave pot-bound balls.
Backfill and finishSite soil, no gravel, little or no amendment; water the ball; berm; 2–4 in (5–10 cm) mulch off the trunk.
Covered in the full lesson
- Hole
- Depth
- Packaging
- Roots
- Backfill
- Finish
Quick check
An exam-style question on this lesson. Open it to see the answer and why.
How wide should a planting hole be?
- About 2 to 3 times the width of the root ball
- Exactly the width of the root ball
- Half the width of the root ball
- 10 times the width of the root ball
Answer: A. Wide holes let new roots grow into loosened soil; depth should not exceed the ball.
The full lesson adds more
In ArboristPass this lesson has a narrated video, five exam-style questions, a sorting drill, flashcards and a printable study sheet, and the course ends with 3 full mock exams.
Previous: Nursery stock: types, quality and inspection · Next: Transplanting established trees