Lesson notesDomain 8: Tree Risk Management · 11% of the exam

Mitigating risk and setting inspection intervals

Tree-based and target-based ways to reduce risk, choosing and recommending mitigation, residual risk, and deciding when to inspect again.

Key points

Tree-basedPruning (remove defective parts, reduce end weight), supplemental support (cabling, bracing, guying; ANSI A300 Part 3), health care, removal.
Target-basedMove the target, restrict access (fences, signs, closures), protect the target.
RecommendingList options, estimate residual risk for each, include costs and limits, set priority and timing.
Inspection intervalSet by the assessor from risk and condition; shorter for active defects and high use; re-inspect after storms and site changes.
ReportsState the interval and limitations: an assessment describes the tree at that time only.

Covered in the full lesson

  • Tree-based
  • Target-based
  • Both

Quick check

An exam-style question on this lesson. Open it to see the answer and why.

Which is a target-based mitigation measure?
  1. Moving a picnic table out of the target zone
  2. Cabling a weak union
  3. Reduction pruning
  4. Removing the tree
Answer: A. Target-based measures change the target, not the tree.

The full lesson adds more

In ArboristPass this lesson has a narrated video, five exam-style questions, a sorting drill, flashcards and a printable study sheet, and the course ends with 3 full mock exams.

See the course

Previous: Defects and conditions that raise the likelihood of failure

All 48 lessons · Free video lessons · About the exam